Why Bosch Dishwasher Starts Then Stops [4 Reasons 2024]

Everything is good when in continuity. Talking about personal experiences, whenever you are listening to your favorite song you want to hear it without any interruption. Similarly, when you are using some kind of electrical appliance, you would want it to work flawlessly without any intervention.

Presently, many Bosch dishwasher users have addressed an issue regarding the discontinuity in the working of their dishwashers. Meaning, the Bosch Dishwasher Starts Then Stops. Kind of irritating, isn’t it? There are various troubleshooting methods available but first you need to understand what the issue is actually about.

Bosch Dishwasher Starts then stops – Reasons

The Bosch dishwasher starts and then stops due to the following reasons.

•       Blown thermal fuse
•       Faulty door latch
•       Malfunctioning control board
•       Faulty pump
•       Damaged motor

This article is meant to be guiding you regarding this unusual issue because I can feel you. I have been through the same situation 4 months back.

Bosch dishwasher starts then stops – Reasons and fixes

On my time, I experienced many issues and I want to make sure that you also faced them. The reason for gathering this information will help me to understand what the nature of your issue is. So if your dishwasher:

•       Starts and then stops repeatedly
•       Stops during the cycle
•       Stops 3 minutes in the middle of the wash cycle
•       Starts, stops, beeps, fills and stops
•       Drains and then stops

Did you come across any of these? If yes, then don’t worry as this article contains all the related information. I have mentioned the reasons above. Now it is time to know briefly about them. I will be explaining the problem first and then will guide you about the relevant fix. So stay tuned!

Also Visit: Bosch Dishwasher No Lights on Control Panel [5 Reasons]

Also Visit: KitchenAid Dishwasher Diagnostic Mode [6 Ways to Run]

Also Visit: Maytag Bravos XL Washer Troubleshooting [10 Fixations]

Also Visit: Miele Dishwasher Troubleshooting [Top 5 Fixations] 2024

Also Visit: Bosch Dishwasher Cycles Explained [Complete Guide 2024]

Bosch Dishwasher Starts Then Stops:

I have noticed this thing many times that if there is a blown fuse present then your dishwasher will stop working and won’t start again. On the other hand, the thermal fuse could also be the reason for your non-workable dishwasher. A thermal fuse could become faulty due to overheating. To prevent the unit from getting damaged altogether, the circuit breaker might trip.

Fix method

Purchase a new fuse and replace it with the old one. Also buy a new thermal fuse for your fuse box. In case the breaker has been tripped, bring it back to ON position.

Bosch Dishwasher Stops Mid Cycle and Beeps:

I suggest you not open the unit’s door while the wash cycle is going on. This will bring an interruption in the working cycle. As a result, the wash cycle will start and then stop for 3 minutes.

Another case would be that you have not opened the door in the middle of the cycle but still the cycle stopped. One potential reason for this could be that your door latch has been faulty. The dishwasher will misunderstand the situation and will consider your closed door an open one.

Fix method

One suggestion that I would like to give is to not open the unit’s door in between the cycles. Secondly, replace your faulty door latch with a new one. In case of repairing, you need to make sure that the water supply has been cut off and there is no power to the appliance.

Ø  Precautionary Steps

•       Unplug the appliance
•       Check the breaker, trip it if not already
•       Stop the water supply by using a shut-off valve present under the sink
•       Remove the water supply lines
•       Remove the unit by unscrewing the nuts
•       Slightly remove the unit

Ø  Replacing the latch

•       Remove the panel present in front of the door switch
•       Test the switch using a multimeter
•       Replace your old latch with a new one

Ø  Resetting the dishwasher

Resetting your dishwasher is an important step as it resolves many underlying issues. If there are any bugs present then this reset will surely resolve them. To perform a reset, follow the following steps.

•       Keep holding the “Start” button until the display fades off
•       Wait for the water to completely drain out
•       Start the cycle again
•       Press “Power” and “Start” buttons simultaneously
•       Repeat the above step again
•       Unplug the unit from the power supply
•       Wait for a few minutes before plugging it back

Bosch Dishwasher Starts To Drain Then Stops:

There is a drain pump present in your dishwasher. One end of the hose is connected to the pump while the other end is connected to the sink’s garbage disposal. If the draining is not working properly then you should do the following.

Ø  Check the filters

It is a very important step to check the filters for any clogging or blockages. A dishwasher’s filter might have food particles left within it which could affect the draining. Before investing into expensive solutions, it is recommended to check the condition of your filters first.

Ø  Check for clogs in the air gap

•       You will have an air gap present at the back of your sink, find it
•       Remove this cap manually
•       Clean the material and get it rid of any possible debris

Ø  Check for clogs in the drain hose

•       Disconnect the air gap and drain hose
•       Drain the water to see whether the hose is clogging or not
•       Now run a rinse wash cycle to check for the blockages
•       Use a plumbing device to remove these blockages

Bosch Dishwasher Starts To Fill Then Stop:

Witnessing your dishwasher to fill water but then stopping immediately is due to the presence of a faulty thermal fuse. This component is essential as it protects the circuit board of the unit. I would recommend you to make sure there aren’t any traces of a faulty thermal fuse.

Also Visit: Why Is My KitchenAid Dishwasher Beeping [9 Issues & Fixes]

Also Visit: GE Dishwasher Troubleshooting [7 Fixations of Problem] 2024

Also Visit: Whirlpool Dishwasher Diagnostic Mode [4 Methods]

Also Visit: Bosch Dishwasher cant Change Cycle [5 Things To Do]

Also Visit: Kitchenaid Dishwasher Not Spraying Water 2024

Also Visit: How to Reset a Bosch Dishwasher [Steps For Fixation 2024]

Frequently Asked Questions

Is It Normal For The Dishwasher To Start And Stop?

Yes, it is normal for many dishwashers to start and stop. This happens because the unit is taking some essential steps like soiling out food particles etc. So if this happens with you then don’t worry because there is nothing to worry about.

What is the most common reason a dishwasher stops working?

The most common reason for a dishwasher to stop working is the presence of a tripped circuit breaker. Make sure the circuit breaker is not tripped so you can easily bring your dishwasher back to working.

Verdict:

In conclusion, if your Bosch dishwasher starts and stops then it is for sure a concerning situation but not that much. You can easily troubleshoot this problem by following my mentioned-methods above. However, if the issue is something else then you can contact a technician for the job.